Close

AirFit F20

Sizing the AirFit F20

To comfortably fit a broader range of patients, AirFit F20 features an entirely new cushion design. To make crosswalking your existing patients easier, we recommend using our sizing guide – included in each AirFit F20 box and specifically designed to help patients find the right fit. You can also download a copy of our sizing guide here.

The arrow of your sizing guide should align with the top of your patient’s nasal bridge. The segment of the guide corresponding with the crease below your patient’s lower lip will indicate their best fit. If a patient falls between sizes, we recommend selecting a larger option for greater comfort.

AirFit F20 has three cushion sizes – small, medium and large. The modular design of the AirFit F20 means each size cushion easily clicks into the same mask frame.

Your patients can also download a copy of our sizing guide from the ResMed website.

Fitting the AirFit F20

  1. Unclip EasyClick Magnets.
  2. With your patient holding the mask towards their face, slide the headgear over the back of their head.
  3. Reclip EasyClick Magnets.

Once your patient’s headgear and mask are properly fitted, you can use the upper and lower headgear straps to help fine-tune their fit. This is also a good opportunity for your patient to reseat their cushion for comfort. When fitting is concluded, the cushion membrane should be fitting comfortably over your patient’s nasal bridge.

For additional information on mask maintenance and care, you can also visit the Supporting your patients section.

Fitting the AirFit F20

  1. Unclip the EasyClick Magnets.
  2. With the mask held against your face, pull the headgear over your head. Ensure the top of the mask cushion is sitting comfortably at the top of your nasal bridge. The bottom of your headgear should settle comfortably at the top of your neck – with the top of the headgear sitting on your crown.
  3. Bring each of the magnets up to meet their corresponding clips on the frame.
  4. Adjust the tabs on the upper headgear.
  5. Adjust the tabs on the lower headgear.
  6. With your device still switched off, connect your device tubing to your mask elbow.
  7. Connect the elbow to your mask.
  8. To ensure your fit will work with your therapy: Switch on your device and position yourself as if you are to begin therapy (e.g. lying down in bed). Adjust your upper straps. Adjust your lower straps. Practice reseating your cushion – pull your mask away from your face, allow your cushion to reinflate, and then resettle the inflated cushion so the cushion membrane is sitting at the top of your nasal bridge.

How to disassemble

  1. Print your ResMed sizing guide. Remember to print to scale.
  2. Trim your guide from the paper.
  3. Using a mirror, hold your sizing guide to your face. The top of the guide should correspond with the highest part of tour nose bridge—just between your eyes.
  4. The lower part of the guide indicates which mask size is best for your face. The size that aligns just below your lower lip will be your best fit.

Cleaning your AirFit F20 (Daily)

  1. Disassemble mask.
  2. Rinse frame, elbow and cushion under running water. Clean each component with a soft brush.
  3. Soak components in warm water with mild liquid detergent for up to ten minutes.
  4. Shake components in water.
  5. Brush moving parts of elbow and around vent holes.
  6. Brush areas of frame where arms connect, and inside and outside the frame where the elbow connects.
  7. Rinse components under running water.
  8. Leave components to air dry out of direct sunlight – making sure to squeeze the arms of the frame to ensure excess water is removed.

How to reassemble

  1. Print your ResMed sizing guide. Remember to print to scale.
  2. Trim your guide from the paper.
  3. Using a mirror, hold your sizing guide to your face. The top of the guide should correspond with the highest part of tour nose bridge—just between your eyes.
  4. The lower part of the guide indicates which mask size is best for your face. The size that aligns just below your lower lip will be your best fit.

Haircare Tips for AirFit F20

 

 

 

 

 

 

 

 

 

 

 

 

 

 

These instructions are for general information purpose only. For full details consult the user guide.

Helpful resources
For additional therapy assistance.

AirFit F20 Product Guide
AirFit F20 User Guide
AirFit F20 Sizing Guide

More support

Setting up your equipment
Tips and guidelines to set up your therapy equipment correctly.
Following up on your treatment
With your therapy underway and equipment set up, the one last and important step of this journey is following up on your treatment. Here’s what you need to know.
Traveling with your equipment
All you need to know about traveling with your therapy equipment, from using a universal power supply to altitude adjustment.
By continuing to browse this site, you give consent for cookies to be used. We use cookies to give you the best possible experience on our website. Change settings or learn more. or Learn more

Manage your preferences regarding cookies

A cookie is a small piece of data that a website asks your browser to store on your computer or mobile device. Please choose whether our website may use statistic or / and marketing cookies, as explained below:

Required cookies

These cookies are essential to the functioning of the site.

Analytical cookies

These cookies allow ResMed to analyze the website usage to measure and improve performance.

Marketing cookies

These cookies are used to help better advertise depending on your interests.
By closing the popup, your preferences are kept throughout the session, until you change them.